- #Diskinternals linux reader pro serial install#
- #Diskinternals linux reader pro serial update#
- #Diskinternals linux reader pro serial full#
Scanning usb for storage devices… 4 Storage Device(s) found Scanning bus 0 for devices… Unknown request, typeReq = 0x200c Endpoint 1 In Interrupt MaxPacket 8 Interval 255ms.Scanning usb for storage devices… 0 Storage Device(s) found Scanning bus 0 for devices… 1 USB Device(s) found : Press battery status buttom, go into recovery mode… Net: Hit Esc or Tab key to enter console mode or rescue linux: 0 Thank you so much, but repair my MPWP is fail Question is if it was worth all the time invested, but I’m satisfied now and also I have learned lot of things about linux thanks to this I was quite frustrated at this moment, but at last I did System reset via web UI as a last resort before ordering UART and Voila! After that I have MPW SSD 512GB fully functional.I tried apply chmod and chown to /media/sdb1, but it didn’t help with NAS bug, but maybe it also played its role.
#Diskinternals linux reader pro serial install#
setup the drive via web UI, but first it throws error during Plex install and in the main UI there was strange disk size and UI says it is MPW SSD 256GB and there was NAS bug (disk not writable via network). after several minutes disk and wifi led both lit on and there were both wifi ready to connect (password is last 8 digit from new SSD drive SN, don’t forgot to note it). #Diskinternals linux reader pro serial full#
turn on MPWP and immediately hold SD button for 5 seconds (I forgot this many times and ended up with full led flashing).
#Diskinternals linux reader pro serial update#
put SSD to MPWP, insert SD with firmware MyPassportWirelessGen2_1.04.17.bin in update folder and plug power (not from PC). connect new ssd to windows and format fat32 partition to exfat (parted I have does not support exfat). dd 8457136 sectors from old drive to new (careful here, with dd you can mess things up easily and I’m not sure if this step is necessary). connect new blank SSD X600 512GB to linux (I have bought this model because someone here had success with it), create GPT, create FAT32 primary partition, leave 8457136 sectors at the end (orginal disk has 190MB EFI partition in the beginning, that is not needed). There I realized the drive has total 5860533168 sectors and last 8457136 are not used (there are all those hidden partitions) take 3TB drive out and connect to virtualbox linux machine. My steps are following, and some of them may be unnecessary: Thanks to all for all information you have posted here, based on them and after a few trials and stucks I have managed to convert MPWP 3TB to MPW SSD with Sandisk X600 512GB. Successfully upgraded MPWP 3TB with 512GB SSD
0 kommentar(er)
